Skip to main content
PRESS RELEASE 2019-09-04

Same toolholder for Grooving and Threading

SmiCut continues to develop their FourCut Threading Tool. It is now available for Grooving applications.
No anvil is needed as extra clearance is ground on the flanks to give better cutting conditions. It means you don’t have to think about helix angle and which anvil to choose when threading. Same toolholder is used for all thread with pitches up to 3,5 mm and now also for grooving up to 3,5 mm width.
FourCut Grooving

Grooving inserts are now available for FourCut threading tool. Use same toolholder for threading and grooving.

Documents

FourCut Catalogue 2020 (PDF)

Links

FourCut - Thread Turning from SmiCut
Similar Posts
smiprog video series
Technical Information

Tutorial Video Series: SmiProg – Software for Thread Milling

SmiProg is very helpful for getting the best out of your thread milling tool. It…
Press Release
SmiCut uses environmentally friendly electricity to manufacture tools
Press Release
End Mills with Short Cutting Length
Technical Information
Video: Thread Milling Education
Illustration av gängfräsning
Technical Information
How to choose correct Thread Mill Diameter
fourcut-extra-accessibility
Products
FourCut – Toolholders with Extra Accessibility

Watch video about FourCut